Kodak NOVAJET 700 User Manual
Page 144
5-32
Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
THIS PIECE OF PLASTIC
(ONE ON EACH SIDE) MUST
CLEAR THE RIDGES ON THE
UNDERSIDE OF THE HOLDER
PUSH DOWN ON
CLIP, PUSH DOWN
ON ENCODER,
THEN PULL OUT
TO REMOVE PAPER
SENSOR BOARD, GRASP
HERE AND PULL UP
Figure 5-18. Paper and Encoder Sensor Removal.
2. To remove the Paper Sensor:
a. Unlock the connector at J3 and remove the flex cable.
b. Turn the Carriage Assembly over and hold it while firmly
grasping the Paper Sensor between thumb and index finger. See
Figure 5-18.
c. Pull straight up on the Paper Sensor and remove it from the
Carriage Assembly.
3. To remove the Encoder Sensor:
a. Unlock the connector at J2 and remove the flex cable.
b. Turn the Carriage Assembly over and lay it with the top side
facing down.