Siemens 108 - Manual (Page 68)

66
Administration
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-2-7619 / admin.fm / 23.12.2005
Te
m
plat
e 20
05_0
5_02
System Password
You can assign a System Password for the configuration environment of your Gigaset
WLAN Repeater 108, and specify the period after which a session is to end automatically
if no further entry is made.
ì
In the Administration menu, select System Password.
After installation, the Gigaset WLAN Repeater 108 configuration is protected by the
System Password admin. To prevent unauthorised changes to the configuration, you
should change the System Password. You may have already set a System Password when
setting up the Security Setup Wizard. If so, you can change it here.
ì
Enter the current System Password in the Current password field.
ì
Enter a new password in the New password field, and repeat it in the
Confirm new password field.
The password may contain up to 20 characters. The password is case sensitive. Avoid
proper names and words that are too obvious. Use a combination of letters, numbers
and special characters.
Note:
Only one connection to the configuration environment can be started at any one
time.
Please note:
If you ever forget your System Password, you will have to reset your Gigaset WLAN
Repeater 108 (see page 11). Please bear in mind that this will restore all the settings
to the factory configuration. The password is reset to the default setting admin.