Operating mode selection – Siemens 108 User Manual
Page 25
23
Basic Setup Wizard
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-2-7619 / basic_config.fm / 23.12.2005
Te
m
plat
e 20
05_0
5_02
Operating Mode selection
You can operate the Gigaset WLAN Repeater 108 in the following modes:
u
Repeater or access point (see page 24)
u
Ethernet Adapter (see page 30)
In the factory setting, the Gigaset WLAN Repeater 108 is configured as a repeater.
You can find more information about the operating modes in the chapter "Possible uses"
on page 5.
ì
If you wish to change the default settings, select the desired Operating Mode from
the selection menu.
ì
Click on Next >.
The basic settings for the Repeater and access point operating modes are described in
the next section, the basic settings for the Ethernet adapter Operating Mode can be
found on page 30.
If you change the Operating Mode, you will be prompted to restart the device after com-
pleting the basic settings.
Please note:
The Gigaset WLAN Repeater 108 can be used as an access point. However, if it is
configured as a repeater or Ethernet adapter and the term access point is used in this
context in this user guide, a different device, such as a Router Gigaset SE551WLAN
dsl/cable or another Gigaset WLAN Repeater 108 configured as an access point is
intended.