Siemens 108 User Manual
Page 56
54
Configuring the Advanced Settings
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-2-7619 / advanced_config.fm / 23.12.2005
Te
m
plat
e 20
05_0
5_02
Super G (only Repeater and Access Point Operating Mode)
With the aid of channel bundling, the
transmission mode enables wireless data
transfer up to 108 Mbps. The channel for wireless data transfer is statically set. You can
only use Super G if this function is supported by at least one client in your wireless net-
work. For the best possible data transfer rates, all clients in your LAN should support
Super G.
ì
Select the mode for using Super G (108 Mbit/s) for your wireless network to
increase the speed of data transfer. You can choose between two modes.
– Static: Wireless transmission is at a rate of just 108 Mbps. Clients that do not
support this speed cannot connect to the access point.
– Dynamic (default setting): if you select this transmission mode, the router
accepts participants who communicate at different transfer rates and adjusts to
the slowest client in the network.
ì
If you do not wish to use Super G (108 Mbit/s), please select Disabled from the
selection menu.
XR (extended range, only Repeater and Access Point Operating Mode)
Activating XR enables wireless data transfer even in the peripheral areas of your wireless
network, albeit at very low data transfer rates. Conversion to XR mode occurs automat-
ically when the signal is weak enough and if the partner station is also XR capable.
ì
Activate or deactivate
for your wireless network.
ì
Click on OK to apply the settings.
Please note:
If you activate Super G as the transmission mode but it is not supported by all compo-
nents in your wireless network, for technical reasons, the transmission rate in the net-
work may be significantly lower than the possible maximum of 108 Mbit/s.