Siemens 108 - Manual (Page 52)

50
Configuring the Advanced Settings
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-2-7619 / advanced_config.fm / 23.12.2005
Te
m
plat
e 20
05_0
5_02
You can specify static IP addresses for individual PCs which are then assigned by the
DHCP server.
ì
Enter the MAC address of the PC and the required IP address in the relevant fields.
ì
Click on Add.
ì
Click on OK to apply the settings.
ì
You should restart all the devices once all the configuration settings have been
made.
Ethernet adapter Operating Mode
ì
In IP address type, specify whether the Gigaset WLAN Repeater 108 should obtain
its IP address automatically from an external DHCP server in the network or not.
– If you want to use a static IP address for your Gigaset WLAN Repeater 108 (factory
setting for the IP address is 192.168.2.254), select the Static option and enter the
IP address and subnet mask in the fields underneath. Make sure that the IP
address you assign complies with the conventions for private IP addresses
described on page 100.
Please note:
If you use the Gigaset WLAN Repeater 108 in Access point Operating Mode and the
integrated DHCP server has been activated, configure the network settings for the
connected PCs so that the Obtain an IP address automatically option is activated.
For more information about this please turn to "Assigning IP addresses automatically"
on page 93. If you deactivate the Gigaset WLAN Repeater 108's DHCP server, you will
have to assign a static IP address for the PCs via the network settings unless there is
another DHCP server on the network. This is described on page 100.