Siemens 108 - Manual (Page 36)

34
Basic Setup Wizard
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-2-7619 / basic_config.fm / 23.12.2005
Te
m
plat
e 20
05_0
5_02
You should now make the settings for network security.
ì
Click on Finish. The basic settings you have made are saved.
ì
This takes you to the Security Setup Wizard, which is described from page 35
onwards.
ì
If you want to make the security settings later, you can deactivate the relevant
option and then click on Finish.
If you have changed the default settings the device is restarted.
Please note:
u If you wish to connect to an access point, on which the encryption of data is acti-
vated, after running the Basic Setup Wizard go straight to the Security Setup Wiz-
ard and enter the same data for encryption.
u If you do not immediately run the Security Setup Wizard for an access point with
encryption, or if the keys or the type of encryption do not match, the PC cannot
establish a connection to your Gigaset WLAN Repeater 108. This is because
there is no accessible DHCP server, or the PC and repeater do not have static IP
addresses. In this case, you must reset the Gigaset WLAN Repeater 108 to the
factory settings (see section "Reset" on page 11) and run the Basic Setup Wizard
again.
u The access point with which the Gigaset WLAN Repeater 108 is to communicate
must be ready for use before the PC, games console or the set-top box to which
the Gigaset WLAN Repeater 108 is to be connected is booted up.
u The appendix contains an example of basic settings for wireless connection of
games consoles and set-top boxes (see page 80).