Siemens 108 - Manual (Page 110)

108
Appendix
Gigaset WLAN Repeater 108 / englisch / A31008-M1030-B101-2-7619 / appendix.fm / 23.12.2005
Te
m
plat
e 20
05_0
5_02
ì
Enter the command IPCONFIG and press the ENTER key.
After a few moments, the configuration of all your network adapters will be dis-
played. Frequently there is only one. If there is more than one, note the name of the
card that is responsible for the connection to the LAN.
The address in the Default gateway line is important. This must contain the IP
address of the Gigaset WLAN Repeater 108.
ì
When prompted, enter the command IPCONFIG /RELEASE and then the name of
the network adapter that is to be given the correct IP address, in this example
"Wireless network connection".
Example: IPCONFIG /RELEASE "Wireless network connection"
You must include the quotation marks if the name contains a space. You can also
specify the name with a wildcard (joker).
Example: IPCONFIG /RELEASE Wire*
This command will affect all the network cards whose name starts with Wire.
ì
Press the ENTER key.