Sun Microsystems 6.0005E+11 - Manual (Page 94)

3-22 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
3
3. Remove the two screws that secure the SBus card to the back panel.
Save the screws for installation of a replacement SBus card or a filler panel.
4. Unlock the SBus card by pulling up the tips of the two standoffs.
See Figure 3-14.
5. Hold the card by the edges near the connector and gently rock the card
back and forth to loosen it from the socket.
You may have to remove the SBus cards or the FFB card next to this card in
order to have enough room to hold onto the SBus card being removed.
Caution – The connector housing may break if the SBus card is tilted too far.
6. Lift the SBus card from the socket at an angle while guiding the face plate
out from the back panel opening.
See Figure 3-15.
Figure 3-15 Removing or Installing an SBus Card
!