Sun Microsystems 6.0005E+11 - Manual (Page 154)

8-6 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
8
Figure 8-5 CD-ROM/Tape Drive Removal and Replacement
Note – If there are two devices in the enclosure, the data and power cables
must be removed from both devices before pulling out the enclosure.
4. Once the cabling is removed, remove the device enclosure from the SCSI
tray.
5. Remove the drive.
a. To remove a CD-ROM drive, remove two screws from each side where
the device is secured to the device enclosure and then proceed to
Step 7.
b. To remove a tape drive, remove 2 screws from each side where the tape
is fastened to the device enclosure, and then remove 4 screws securing
the device to the enclosure side plate.
Proceed to step 7.