Sun Microsystems 6.0005E+11 - Manual (Page 66)

3-18 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
3
b. Tighten to 6 inch-pounds in the same tightening sequence.
Caution – Do not over-torque or under-torque the screws. Excessive force can
warp the connector. Insufficient force can cause an incomplete electrical
connection.
Figure 3-12 Tightening Compression Connector Screws
7. Use the procedures in Section 3.4.2, “Installing a Board,” to replace the
applicable CPU/Memory board.
4 1 3
2
5
4 1 3
2
5
Tightening sequence
!