Turn off the system power in this order, A. external drives and expansion cabinets (if any), B. system cabinet – Sun Microsystems 6.0005E+11 User Manual
Page 194: C. terminal, Turn the ac power sequencer power switch to off, Figure 12-1, Keyswitch standby position (cabinet system), See figure 12-1 (cabinet)
12-2
Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
12
3. Halt the system using the appropriate commands. Refer to the Solaris
Handbook for SMCC Peripherals that corresponds to your operating system.
4. Wait for the system-halted message and the boot monitor prompt.
5. Turn off the system power in this order:
a. External drives and expansion cabinets (if any)
b. System cabinet
c. Terminal
6. Turn the front panel key switch to the Standby position.
See Figure 12-1.
7. Turn the AC power sequencer power switch to Off.
The power sequencer is at the rear of the cabinet. See Figure 12-2.
Caution – Before attempting to service the system cabinet, turn off the AC
power on the rear of the system.
Figure 12-1 Keyswitch Standby Position (Cabinet System)
!
Standby