beautypg.com

2 scsi tray, Remove the top bezel, Figure129 removing the scsi tray – Sun Microsystems 6.0005E+11 User Manual

Page 217: 5 powering on the system, 2 scsi tray -13, 5 powering on the system -13, Figure 13-9, Removing the scsi tray -13, Powering on the system

background image

Preparing for Service

12-13

12

12.4.2 SCSI Tray

To remove the SCSI tray:

1. Remove the top bezel.

2. Loosen the three captive screws that hold the tray in place.

Insert a screwdriver in the notch at the top center of the SCSI tray to pull
out the SCSI tray. See Figure 12-9.

3. Remove the seven screws on top of the SCSI tray to lift off the tray cover

to access CD and tape drives.
See Figure 12-9.

Figure 12-9 Removing the SCSI Tray

To replace the SCSI tray, reverse these procedures.

12.5 Powering On the System

See Section 12.3, “Restarting the System,” to power-on after all panels have
been replaced.

Notch used

to pull out tray

See also other documents in the category Sun Microsystems Hardware: