Place the card in an antistatic bag, Figure 4-22, Removing or installing a graphics (upa) card – Sun Microsystems 6.0005E+11 User Manual

Page 101: Figure 3-22

Text mode
Original mode

I/O Boards and Components

3-29

Figure 3-22 Removing or Installing a Graphics (UPA) Card

7. Place the card in an antistatic bag.

8. If the graphics (UPA) card is not immediately replaced, install a filler

panel (part number 340-2305) on the Graphics I/O board back panel
opening. To secure the filler panel, use the screws that were removed in
Step 3.

Caution – Be sure to install the filler panel right-side up. Installing it upside
down creates a gap at the top edge of the card slot opening that can impair
system cooling and regulatory compliance.

9. Use the procedures in Section 3.5.3, “Installing a Board,” to replace the

Graphics I/O board.