Sun Microsystems 6.0005E+11 - Manual (Page 231)

Functional Description B-7
B
B.5 CPU/Memory Board
The CPU/Memory board supports up to 2 CPU modules and 16 SIMMs. The
CPU/Memory board is shown in Figure B-5.
Figure B-5 CPU/Memory Board
The CPU/Memory board should be installed from the smallest even-numbered
slot (0) to the largest even-numbered slot (14). The even-numbered slots are
located at the front of the cabinet. When located in these slots, the component
side of the board is down. If the front slots are filled, you can use slots at the
rear of the cabinet, with the exception of slot 1. Slot 1 requires an I/O board
because the slot connects to the SCSI tray in the front of the cabinet.
All empty slots must have a filler panel or load board installed.
Note – The 16-slot Enterprise 6000 card cage requires load boards to reduce the
potential for RFI generation. The 8-slot Enterprise 5000 and 4000 card cages use
filler panels, which do not have load circuits.
Board lock (x2)
Extractor lever (x2)
LEDs
CPU 0 slot
CPU 1slot