6 side panels, Tilt the panel bottom out, Figure124 removing the side panels – Sun Microsystems 6.0005E+11 User Manual

Page 211: Tighten the two captive screws at the panel base, Figure 13-4, Removing the side panels

Preparing for Service

12-7

12.3.6 Side Panels

To remove the left and right side panels:

1. Loosen two slot-head captive screws near the panel base.

2. Tilt the panel bottom out.

3. Lift the panel up until free of the tabs at the top of the chassis.

Set the panel aside.

Figure 12-4 Removing the Side Panels

To replace the side panels:

1. Place the panel against the cabinet so the notches on the panel inside

align with tabs at the chassis top.

2. Lower the panel into place and allow it to hang flush against the chassis.

3. Tighten the two captive screws at the panel base.

Captive screws

Side panel

Chassis tab

Panel notches