Sun Microsystems 6.0005E+11 - Manual (Page 157)

Internal SCSI and Storage Devices 8-9
8
Figure 8-7 SCSI Tray Removal and Replacement
4. Remove the seven screws on top of the SCSI tray to lift off the tray cover
to access CD-ROM and tape drives.
5. Remove a CD-ROM or a tape drive:
a. Loosen the three captive screws securing the device to the tray.
b. Remove the mounting plate of the device being replaced and attach it
to the replacement device using the same screws.
c. Set the replacement device SCSI address to 6 for a CD-ROM drive, 5
for a tape drive.
d. Secure the replacement device to the caddy by tightening the three
captive screws on the mounting plate.
e. To complete the replacement, reverse Step 1 and Step 2.
Notch