Sun Microsystems 6.0005E+11 - Manual (Page 280)

E-32 Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
E
6. Loosen the bottom three captive screws securing the SCSI tray to the
enclosure.
Insert a screwdriver in the notch at the top center of the SCSI tray to pull
out the tray and separate it from the rear slip connectors. See Figure E-18.
Figure E-18 Removing the SCSI tray
7. Remove the key switch assembly and the 100/240V fan tray assembly.
See Section E.2.2, “Key Switch Assembly and Section E.2.1, “Fan Tray
Assembly, 100V/240V” for information on removing these assemblies.
8. Turn over the enclosure and remove the feet on the bottom.
a. Locate the four feet in each corner of the enclosure.
b. Unscrew and remove each foot.
9. Turn the enclosure front side down onto a surface.
10. Remove the 26 screws around the center of the main chassis.
11. Lift and remove the rear chassis and set it aside.
12. Remove the 20 screws that hold the centerplane to the front chassis.