Replace the power cable and fan fail cable, To replace the fan tray screen, Replace the two bottom screws on the left – Sun Microsystems 6.0005E+11 User Manual
Page 252: To remove the ac input cable assembly, Completely power off the enterprise system, Disconnect the ac power cord from the power outlet, Unplug the ac power cord from the power inlet, E.1.2 domestic and international system cabinet, Ac input cable assembly
E-4
Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996
E
3. Tighten the two captive screws at the top and bottom of the fan tray.
See Figure E-1.
4. Replace the power cable and fan fail cable.
To replace the fan tray screen:
1. Replace the screen so that the slotted screw holes clear the screw heads.
2. Tighten the top screw on the left and the three screws on the right.
3. Replace the two bottom screws on the left.
E.1.2 Domestic and International System Cabinet AC Input Cable
Assembly
To remove the AC input cable assembly:
1. Completely power off the Enterprise system.
See the power off instructions in Chapter 12, “Powering Off and On.”
2. Disconnect the AC power cord from the power outlet.
3. Push back and release the latch attaching the power cord to the power
inlet.
See Figure E-2.
4. Unplug the AC power cord from the power inlet.
Close the power connector cover over the power inlet.