JVC VR-N1600E User Manual
Page 93
85
[CAMERA CONTROL] Terminal at the Rear
of VR-N900U (VR-N900U)
The analog camera acts as a network encoder (IP video server)
in the VR-N900U system, and the device name assigned to it is
[N900]. The [CAMERA CONTROL] terminal at the rear is
assigned as
ACOM1B on the Camera Settings screen. (A Page
E
Camera Type
For specifying whether the camera corresponding to the selected number is [Fixed] or [Moveable].
Fixed
: Fixed Camera
Moveable
: PTZ Camera
F
Device Port
This option is enabled only if
AMoveableB is selected in the [Camera Type] item E.
For specifying which control port on the network encoder (IP video server) to use for controlling the PTZ features.
G
Port Addr.
This option is enabled only if
AMoveableB is selected in the [Camera Type] item E.
Use this option to specify the port address of the camera. The port address is usually set to
A0B or A1B.
If the PTZ cameras are serially connected, they are identified by their the port addresses. Refer to the camera’s
[INSTRUCRTIONS] for the recommended settings.
VR-N1600_J.book Page 85 Tuesday, June 3, 2008 2:26 PM