JVC VR-N1600E - Manual (Page 135)

127
Communication Settings
To make use of the event audio feature, you need to receive the
communication data for triggering the generic event issued by
an external device using the event audio program, and transfer it
to the alert port of this unit.
You can enter the port number and alert port number (A Page
98) for receiving communication data for triggering the generic
event on the [Communication setting] screen.
Note :
● Do not alter the setting unless under special
circumstances. Altering the settings unnecessarily may
cause the system to malfunction.
1
Click [Communication setting] on the [Event
Audio Setting] screen
● The [Communication setting] screen appears.
Memo :
● To play back an audio file, register the event with [General
Event Settings] of [Camera Record Setting]. (A Page 96)
● External device settings:
● Set the port for receiving the event (51234) as the
alarm output (communication data for triggering the
generic event) destination port of the external device,
such as camera.
● Set the IP address of this unit as the destination IP
address. However, note that the IP address of this unit
is not 127.0.0.1.
● If the audio setting of the camera is set to the half
duplex mode, you will not be able to hear audio sound
from the camera during event audio transmission.
Note :
● If you configure the camera event settings on the [I/O
Setup] screen of [Camera Record Setting] after alarm
output setting for the generic event at the camera is
complete, information of the existing generic event will be
overwritten, and this may cause the system to
malfunction.
● Do not specify the same number for the [Event receive
port] and [Transfer port].
Item Description
A Event
receive
port
For specifying the port number for
receiving communication data for
triggering the generic event issued by an
external device.
B Transfer
port
For specifying the port number to transfer
communication data to.
Memo :
● Main MenuB[Camera Record
Setting]B[I/O Setup]B[Details]B
Specify the same port as [Network
Settings]B[Alert Port]. (A Page 94)
C Transfer
IPaddress
For specifying the IP address to transfer
the generic event to. (Specify the unit itself
using 127.0.0.1)
D OK Closes the [Communication setting]
screen. After setting is complete, press the
[Renew] button on the [Event Audio
Setting] screen to enable the new settings.
E Cancel Closes the [Communication setting] screen
without doing anything.
D
E
A
B
C
VR-N1600_J.book Page 127 Tuesday, June 3, 2008 2:26 PM