JVC VR-N1600E - Manual (Page 34)

26
Basic Operation
Switching the Power On
1
Connect the power cable
● Connect using the power cable supplied to an AC100V
(50 Hz/60 Hz) outlet.
2
Turn AONB the power switch at the rear panel.
● A system check will run when the power is turned on.
● The [OPERATE] indicator starts blinking.
● After blinking, the [OPERATE] indicator lights up to
indicate that operation has been turned on.
● When the setting is complete, recording starts
automatically in the record control mode. (When the
AON at startupB checkbox of [Record Control] under
[Unit Setting] of the main menu is selected. )
Note :
● Do not disconnect the power cord nor turn the power
switch AOFFB while the system check is running or in the
OPERATE ON mode. Otherwise, it may break down.
Switching the Power Off
1
Press and hold the [OPERATE] button for
about2seconds to turn off the power
● After blinking, the [OPERATE] indicator goes off.
2
Turn off the power switch on the rear panel
Note :
● The recorded images may not be played back properly if
they are not archived (A Page 106) before the power
failure.
● It is recommended that an uninterruptible power supply
(UPS) be used to protect the hard disk from damage in
the event of a power failure. (A Page 128)
Switching On/Off Using Operate Button on
Front Panel
You can switch operation to ON or OFF.
Ⅵ Switching Operation On
1
(When Operation is OFF) Press the [OPERATE]
button
● The [OPERATE] indicator starts blinking.
● The [OPERATE] indicator lights up, indicating that
operation is enabled.
Memo :
● When the power switch on the rear panel is turned on, the
system starts up automatically until the OPERATE ON
mode is activated.
Ⅵ Switching Operation Off
1
(When operation is ON) Press and hold the
[OPERATE] button for about 2 seconds
● The [OPERATE] indicator starts blinking.
● The screen display disappears and the [OPERATE]
indicator goes off, indicating that operation has been
turned off.
Note :
● Do not turn off the power until operation has been turned
off.
Switching On/Off Using Input/Output
Terminal on Rear Panel
For details on the layout of the input and output terminals on the
rear panel, refer to [Rear I/O Terminals] (A Page 11).
Ⅵ Switching Operation On
1
(When operation is OFF) Set the [OPE ON/OFF]
terminal to make for at least 50 ms
● The [OPERATE] indicator starts blinking.
● The [OPERATE] indicator lights up, indicating that
operation is enabled.
Ⅵ Switching Operation Off
1
(When operation is OFF) Set the [OPE ON/OFF]
terminal to make for at least 1 s
● The [OPERATE] indicator starts blinking.
● The screen display disappears and the [OPERATE]
indicator goes off, indicating that operation has been
turned off.
Note :
● Do not turn off the power until operation has been turned
off.
Switching the Power On/
Off Switching Operation On/
Off
VR-N1600_J.book Page 26 Tuesday, June 3, 2008 2:26 PM