JVC VR-N1600E - Manual (Page 116)

108
Applications
Ⅵ Reading Preset Data
This section describes procedures for reading the preset data
from the flash memory.
1
Insert the flash memory device into the
[SERIAL] terminal on the front (rear) panel
2
Select [Load Setting Data]
● If data is stored on the flash memory device, a list of
data stored in the device will appear in the preset data
list.
● The [Flash memory cannot be detected] message may
appear in some cases. In this case, wait for about 30
seconds and select [Load Setting Data] again.
● Preset data that is stored on this unit is indicated by
AMy MachineB at the beginning. Data stored on other
NVR units is displayed as
AOther MachineB. This is
followed by a pair of parentheses, which contains the
MAC address of the NVR where data was saved. This
is followed by the saved date/time in the
Ayyyy-mm-dd-
sec-Setting B format.
● If multiple data are displayed, highlight the data in the
list that you want to read.
3
Select the setting to load, followed by pressing
[Load]
● The highlighted data will be read.
4
The [Load Setting Data ] confirmation
message appears. Press [OK].
● The preset data will be read.
● When reading is complete, a message informing you
that data has been read appears. Click the [OK] button.
5
Press [Close] to return to the [Flash Memory
Utility] screen
Ⅵ Removing the Flash Memory Device
1
Select [Remove Flash Memory]
● The [Remove Flash Memory ] confirmation dialog
appears. Press [OK].
● The [Flash Memory was removed] message appears.
Press [OK].
2
Remove the flash memory device from the
[SERIAL] on the front (rear) panel
Memo :
● Items specified in the [Image Quality...] settings of [Main
Menu]-[Camera Record Setting] (A Page 54), [OS
Setting] (A Page 68), and [Password] section of [Unit
Setting] (A Page 65) will not be saved.
● To read the preset data after you have selected [Remove
Flash Memory], remove the flash memory device from the
serial terminal and insert it again. When the flash
memory is inserted, it will be automatically detected.
Note :
● If you are reading preset data saved using a different
language setting, change [Language Setting] of the [Main
Menu] to the language used when the data is saved.
● If a Master/Slave setup is created using Milestone
System’s Enterprise 6.0 on an NVR, settings on that unit
cannot be loaded on another NVR.
● Data saved using VR-N900U cannot be used on VR-
N1600U/E. and vice versa.
Flash Memory Utility
(continued)
[Setting Data List] Screen
VR-N1600_J.book Page 108 Tuesday, June 3, 2008 2:26 PM