Juniper Networks J-Series - Manual (Page 76)

Configuring SNMP with a Configuration Editor
To configure SNMP on a Services Router, you must perform the following tasks
marked (Required). For information about using the J-Web and CLI configuration
editors, see the J-series Services Router Basic LAN and WAN Access Configuration Guide.
■ Defining System Identification Information (Required) on page 54
■ Configuring SNMP Agents and Communities (Required) on page 55
■ Managing SNMP Trap Groups (Required) on page 56
■ Controlling Access to MIBs (Optional) on page 57
Defining System Identification Information (Required)
Basic system identification information for a Services Router can be configured with
SNMP and stored in various MIBs. This information can be accessed through SNMP
requests and either queried or reset. Table 31 on page 54 identifies types of basic
system identification and the MIB object into which each type is stored.
Table 31: System Identification Information and Corresponding MIB Objects
MIB System Information
sysContact Contact
sysLocation System location
sysDescr System description
sysName System name override
To configure basic system identification for SNMP:
1. Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
2. To configure basic system information using SNMP, perform the configuration
tasks described in Table 32 on page 54.
3. If you are finished configuring the network, commit the configuration.
4. To check the configuration, see “Verifying the SNMP Configuration” on page 58.
Table 32: Configuring Basic System Identification
CLI Configuration Editor J-Web Configuration Editor Task
From the [edit] hierarchy level,
enter
edit snmp
1. In the J-Web interface, select
Configuration>View and Edit>Edit
Configuration.
2. Next to Snmp, click Configure or Edit.
Navigate to the SNMP level in the
configuration hierarchy.
54 ■ Configuring SNMP with a Configuration Editor
J-series™ Services Router Administration Guide