Juniper Networks J-Series - Manual (Page 133)

Table 49: Summary of System Process Information Output Fields (continued)
Additional Information Values Field
Sleep state of the process. Sleep state
Time of day when the process started. Start time
Monitoring the Chassis
The chassis properties include the status of active chassis alarms on the Services
Router, environment measurements, a summary of the field-replaceable units (FRUs),
and the status of Physical Interface Modules (PIMs) on the router. To view these
chassis properties, select Monitor>Chassis in the J-Web interface, or enter the
following CLI
show commands:
■ show chassis alarms
■ show chassis environment
■ show chassis fpc
■ show chassis hardware
CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the
maximum power and heat capacity of the chassis. If J-series power management is
enabled, PIMs that exceed the maximum power and heat limits remain offline when
the chassis is powered on. To check PIM power and heat status, use the
show chassis
fpc and show chassis power-ratings commands. For more information, see the Getting
Started Guide for your router.
Table 50 on page 111 summarizes key output fields in chassis displays.
Table 50: Summary of Key Chassis Output Fields
Additional Information Values Field
Alarm Summary
Date and time the alarm was first recorded. Alarm Time
Using the Monitoring Tools ■ 111
Chapter 7: Monitoring the Router and Routing Operations