Juniper Networks J-Series - Manual (Page 127)

Table 47: J-Web Monitor Options and Corresponding CLI show Commands (continued)
Corresponding CLI Commands Function Monitor Option
■ show system services dhcp binding
■ show system services dhcp conflict
■ show system services dhcp pool
■ show system services dhcp
statistics
Displays DHCP dynamic and static leases, conflicts, pools, and
statistics.
For details, see “Monitoring DHCP” on page 143.
DHCP
show services rpm probe-results Displays probe results for all RPM probes configured on the
Services Router, including the round–trip times, jitter, and loss
percentage of probes sent. Additionally, the RPM monitoring page
displays a graph that plots the probe results as a function of time.
For details, see “Monitoring RPM Probes” on page 145.
RPM
■ PPPoE interfaces— show pppoe
interfaces
■ PPPoE statistics— show pppoe
statistics
■ PPPoE version— show pppoe
version
Displays the following PPPoE information:
■ PPPoE Interfaces—Session-specific information about the
interfaces on which PPPoE is enabled.
■ PPPoE Statistics—Statistics for PPPoE sessions currently
active.
■ PPPoE Version—Information about the PPPoE protocol
currently configured on the router.
For details, see “Monitoring PPPoE” on page 148.
PPPoE
■ Dynamic call admission control
information—
show tgm
dynamic-call-admission-control
■ Telephony Gateway Module
information—
show tgm fpc
slot-number
media-gateway-controller and show
tgm fpc slot-number dsp-capacity
■ Telephony Gateway Module
status—
show tgm
telephony-interface-module status
Displays the following TGM550 Media Gateway information:
■ Dynamic Call Admission Control Information—Displays
maximum bandwidth available for voice traffic and the
dynamic call admission control (CAC) properties configured
on the router WAN interfaces.
■ Telephony Gateway Module Information—Displays
information about TGM550 connectivity and digital signal
processor (DSP) capacity.
■ Telephony Interface Module Information—Displays the online
and offline status of telephony interface modules (TIMs)
installed in a J-series router.
For details, see “Monitoring the TGM550 Media Gateway
(VoIP)” on page 151.
Media Gateway
Filtering Command Output
For operational commands that display output, such as the show commands, you
can redirect the output into a filter or a file. When you display help about these
commands, one of the options listed is
| , called a pipe, which allows you to filter the
command output.
For example, if you enter the show configuration command, the complete Services
Router configuration is displayed on the screen. To limit the display to only those
Monitoring Overview ■ 105
Chapter 7: Monitoring the Router and Routing Operations