Impulse PCW-5181 User Manual
Page 40
Chapter 4 - Configuring Impulse with Application Developer
4-16
X-Smoothness #2
Recommended values for M1 and M2 have been pre-configured for IDC motors, but we
recommend that these settings be verified and adjusted if necessary by the following procedure.
5.
Press the Run Test button.
6.
Move slider M1 to approximately 8,000.
7.
Move slider M2 left and right until the smoothest running condition is reached.
8.
Move slide M1 left and right until the smoothest running condition is reached.
9.
Press Stop Test.
X-Smoothness #3
10. Press the Run Test button.
11. Move slider H1 left and right until the smoothest running condition is reached.
12. Move slider H2 left and right until the smoothest running condition is reached.
13. Press Stop Test.
14. Click OK.
See also other documents in the category Impulse Hardware:
- PCM-4373 (2 pages)
- EPIC-5536 (2 pages)
- EPIC-CV07 (2 pages)
- EPIC-QM57 (2 pages)
- EPIC-QM77 (2 pages)
- VSX-6118-V2 (1 page)
- VSX-6116-V2 (1 page)
- VSX-6115-V2 (1 page)
- VSX-6114-V2 (1 page)
- VDX-6318RD (1 page)
- VDX-6316RD (1 page)
- VDX-6315RD (1 page)
- VDX-6314RD (1 page)
- PCM-5895 Rev. A (2 pages)
- PCM-8120 (2 pages)
- PCM-9562 (3 pages)
- VSX-6127-V2 (1 page)
- PCM-9375 (3 pages)
- GENE-5315W1 Rev. B (2 pages)
- GENE-5315 Rev. A (2 pages)
- VDX-6327RD (1 page)
- VDX-6328RD (1 page)
- VDX-6329RD (1 page)
- VDX-6326RD (1 page)
- PCM-9343 (3 pages)
- GENE-9655 (2 pages)
- PCM-9362 (2 pages)
- GENE-LN05W2 Rev. B (2 pages)
- PCM-9363 (3 pages)
- GENE-TC05W2 (2 pages)
- GENE-CV05W2 (2 pages)
- SBC-210 (1 page)
- GENE-QM57 (2 pages)
- GENE-QM67 (2 pages)
- GENE-QM77 Rev B (2 pages)
- GENE-QM77 Rev A (2 pages)
- GENE-QM87 (1 page)
- EL630-NR (2 pages)
- EL620-C (2 pages)
- SB601-C (2 pages)
- SB600-C (2 pages)
- SB630-CRM (2 pages)
- CL630-CRM (2 pages)
- DL631-C226 (2 pages)