Impulse PCM-9562 - Manual

5.25"/ EBX/ EPIC Single Board Computers
All product specifications are subject to change without notice Last updated : 9-May-2011
Features
PCM-9562
Intel ® Atom™ N450/D510 EBX SBC with 3
GbE, 6 COM, 3 SATA, 8 USB 2.0, 2 Watchdog
ƒ Embedded Intel ® Atom™ processor N450 Single Core/D510 Dual Core
1.66 GHz + ICH8M
ƒ Supports up to 3 Intel GbE, 6 COM, and 2 Watchdog timer
ƒ Design complies with UL60601 on GbE3 and COM6 port isolation
(PCM-9562F full version series only)
ƒ Power off protection and Software I 2 C API support
ƒ Supports embedded software APIs and Utilities
Specifications
Processor System
CPU Intel Atom N450/D510 1.66 GHz
Front Side Bus 667MHz
Frequency Atom N450/D510 1.66 GHz
L2 Cache 512 KB/1 MB
System Chipset N450/D510 + ICH8M
BIOS AMI 16 Mbit
Memory
Technology DDR2 667 MHz
Max. Capacity 2 GB
Socket 1 x 200-pin SODIMM
Display
Chipset N450/D510
VRAM Optimized Shared Memory Architecture up to 224 MB
Graphics Engine Embedded Gen3.5+ GFX Core, HW MPEG2 decoder
LVDS Single channel 18-bit LVDS up to WXGA 1366 x 768
VGA
N450: Up to SXGA 1400 x 1050 @ 60 Hz (SXGA)
D510: up to 2048 x 1536 (QXGA)
Dual Display VGA+ LVDS
Ethernet
Interface 3 (RJ-45 connector through the cable and Ethernet3 is Full version only)
Controller GbE1 Intel 82567, GbE2 Intel 82583V, GbE3 Intel 82583V (UL60601 Compliant)
Connector Box header
Audio
Chipset ALC888 HD Codec, Speaker out, CD-input, Line-in, Line-out, Mic-in
Amplifier Max 2.2W/ch Stereo into a 3 Ω Load
WatchDog Timer
Output System reset
Internal
Watchdog timer1 (IWT): monitor the system status before OS is ready (programmable 10ms, disable, 1s, 60s)
Watchdog timer2 (PWT): monitor the application status after OS is ready (programmable 1 - 255 sec/min) (Full version only)
Storage
CompactFlash Card Type I, Type II
SATA 3 SATA II (Max. Data Transfer Rate 300 MB/s)
Floppy Share with LPT (Optional)
SPI Flash 16 Mbit
Internal I/O
Serial
4 x RS-232 (COM1/2/3/6, isolation design in COM6 is Full version only)
2 x RS-422/485 (COM4/5, default RS-422/485, RS-232 with TX/RX only is optional by request)
ESD protection for RS-232: Air gap ±15kV, Contact ±8kV
Ethernet GbE x 3 (RJ-45 connector through the cable and GbE3 is Full version)
PS/2 KB/Mouse 1
VGA 1
Reset Button 1
USB 8 x USB 2.0
Parallel (LPT) 1
FDD Share with LPT (Optional)
GPIO 16-bit GPIO
SMBUS 1
I2C 1
Expansion
PC/104-Plus slot 1
Mini PCI Express 1
PCI Slot 1
Power
Power Type AT / ATX (Both AT/ATX can support ACPI)
Power Supply Voltage
ATX: 12V ±10%, 5VSB ±5% (5V stand-by power is only for auto power off function)
AT: 12V ±10% only
Power Consumption (Typical)
PCM-9562N-S6A1E: 10.8 W (893 mA @ 12 V, 8 mA @ 5 VSB)
PCM-9562D-S6A1E: 13.6 W (1130 mA @ 12 V , 10 mA @ 5 VSB)
Power Consumption
(Max, test in HCT)
PCM-9562N-S6A1E: 13.9 W (1159 mA @ 12 V, 6 mA @ 5 VSB)
PCM-9562D-S6A1E: 16.9 W (1404 mA @ 12 V, 8 mA @ 5 VSB)
Environment
Operating 0 ~ 60° C (32 ~ 140° F) (Operating humidity: 40° C @ 95% RH non-condensing)
Non-Operating -40° C ~ 85° C and 60° C @ 95% RH non-condensing
Physical Characteristics
Dimensions (L x W) 203 x 146 mm (8" x 5.75")
Weight 0.85 kg (1.87 lb) (with Heatsink)
Total Height
(with cooler + PCB + Bottom)
29.6mm (PCM-9562N/NF), 38.6mm (PCM-9562D/DF), 44.6mm (PCM-9562Z/Z2)
Monitoring eSOS Embedded
Security ID
Flash Lock
Watchdog GPIO H/W Monitor Brightness I 2 C SMBus Backlight On/Off
Software APIs:
Utilities:
BIOS Flash
GbE3 Inverter SMBus
PCI Slot JP1
JP2 GbE1 -5/-12V Reset
Power input
System FAN
5VSB
SATA 1/2/3
JP4
COM2
COM1
COM6
COM3
COM4/5
LPT
KB/MS
SIR
SATA Power connector
GbE2 PWR
GbE1/2 LED USB 1~8
Power/HDD LED
JP7 GPIO
PC-104 Plus
USB FAN
VGA
CD in
JP3
LVDS
Audio
GbE3 LED