Impulse PCM-9375 User Manual
Pcm-9375, Features, Specifications
3.5" Single Board Computers
All product specifications are subject to change without notice
Last updated : 9-May-2011
Features
PCM-9375
AMD Geode™ LX800 3.5" SBC, VGA, LVDS,
LCD, 2 Ethernet, IDE, SATA, PC/104
AMD Geode™ low power LX800 500 MHz processor
24-bit TFT LCD interface, 18-bit LVDS LCD display
Dual 10/100 Mbps Fast Ethernet
Supports up to 4 COM ports, 4 USB ports, PC/104 expansion
Supports embedded software APIs and utilities
LCD Inverter
PC/104
COM 1
LAN 1 KB/MS USB
VGA USB Reset button
ATX
Power button
SATA
GPIO
Audio
TFT LCD
Printer
COM2, 3, 4 Stand-by Power
Power
Specifications
Processor System
CPU
AMD Geode LX800 processor, up to 500 MHz
Frequency
500 MHz
L2 Cache
128 KB
System Chipset
AMD Geode LX800
BIOS
Award 4 Mb Flash ROM BIOS
Memory
Technology
DDR 333/400 MHz
Max. Capacity
512 MB
Socket
1 x 200-pin SODIMM
Display
Chipset
AMD Geode LX800
VRAM
Optimized shared memory architecture up to 64 MB system memory
Graphics Engine
AMD CS5536 2D engine
LVDS
1 x Single channel 18-bit LVDS (PCM-9375E), up to 1600 x 1200 x 32 bpp at 60 Hz
VGA
VGA: up to 1920 x 1440 @ 32 bpp (85 Hz)
TTL LCD
1 x 24-bit TTL (PCM-9375F), up to 1600 x 1200 x 32 bpp at 60 Hz
Dual Display
VGA+TTL, VGA+LVDS
Ethernet
Speed
10/100 Mbps (Supports Wake on LAN)
Controller
Ethernet1 Realtek RTL3139 10/100 Mbps
Ethernet2 Realtek RTL8139 10/100 Mbps
Connector
RJ-45 on Ethernet1, box header on Ethernet2
Audio
Chipset
Realtek ALC203 AC97, Line-in, Line-out, Mic-in
WatchDog Timer
Output System reset, Programmable counter from 1 ~ 255 minutes/ seconds
Storage
CompactFlash
1
SATA
1 x SATA (Max. Data Transfer Rate 150 MB/s) (only for PCM-9375S)
IDE
1 (only for PCM-9375F/9375E)
Floppy
1 (Shared with LPT)
Rear I/O
Serial
1 (COM1 supports RS-232) (ESD protection for RS-232: Air gap ±15kV, Contact ±8kV)
Ethernet
1 (10/100 Mbps)
PS/2 KB/Mouse
1
VGA
1
Reset Button
1
Internal I/O
USB
4 x USB 2.0
Serial
3 x COM (ESD protection for RS-232: Air gap ±15kV, Contact ±8kV)
COM3/COM4 supports RS-232
COM2 supports RS-232/422/485 (Supports RS-485 auto flow control)
IDE
1 UDMA 33/66
Parallel (LPT)
1 (Shared with LPT)
FDD
1 (Shared with LPT)
GPIO
8-bit GPIO
I2C
optional
Expansion
PC/104 Slot
PC/104 Expansion(8/16-Bit ISA)
Power
Power Type
AT/ATX
Power Supply Voltage
5V + 5% (+12V option for LCD, PC/104)
Power Consumption (Typical)
Typical: 0.6 A @ 5 V, 0.03 A @ 12 V
Power Consumption
(Max, test in HCT)
MAX: 1.2 A @ 5 V, 0.23 A @ 12 V
Power Management
APM 1.2, ACPI
Battery
Lithium 3 V/196 mAH
Environment
Operational
0 ~ 60° C (32 ~ 140° F) (Operating humidity: 40° C @ 95% RH non-condensing)
Non-Operational
-40° C ~ 85° C and 60° C @ 95% RH non-condensing
Physical Characteristics
Dimensions (L x W)
146 x 102 mm (5.7" x 4")
Weight
0.85 kg (1.87 lb), weight of total package
Total Height
25.2mm
LAN2
Watchdog
GPIO
H/W Monitor
Monitoring
BIOS flash
Software APIs:
Utilities:
Backlight
On/Off
Brightness
SMBus
VxWorks
®