Gateway 9415 - Manual (Page 95)

90 www.gateway.com
Replacing the power distribution board
To replace the power distribution board:
1
Follow the instructions in “Preventing static electricity discharge” on page 41 . Make
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in “Opening the server case” on page 42 .
3
Follow the instructions in “Removing the power supply air duct” on page 49 .
4
Remove the power supply modules by following the instructions in “Replacing a
power supply module” on page 88 .
5
Disconnect the main power, CPU power, and power signal cables from the system
board. See
“System board” on page 6 for the location of the connectors on the system
board.
6
Disconnect the PCI fan from the power distribution board.
7
Disconnect the power cables from the power distribution board and the hot-swap
backplane.
8
Disconnect the drive cables and drive power cables from the backplane.
8510522.book Page 90 Wednesday, March 16, 2005 11:19 AM