Gateway 9415 - Manual (Page 57)

52 www.gateway.com
Installing a diskette in a converted hard drive bay
If you need to install a slim-line diskette drive into your server, you must install the diskette
drive in the center hard drive bay.
To install a diskette drive in a converted hard drive bay:
1
Follow the instructions in “Preventing static electricity discharge” on page 41 . Make
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in “Opening the server case” on page 42 .
3
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
4
Remove the center hot-swap hard drive carrier from the server.
5
xxxRemove the rails from the diskette drive conversion kit carrier by removing the
four screws that secure the rails to the carrier.
Caution The diskette drive is not hot-swappable. Before installing or removing
the drive, make sure that power is turned off and the power cord is
unplugged.
8510522.book Page 52 Wednesday, March 16, 2005 11:19 AM