Gateway 9415 - Manual (Page 18)

13 www.gateway.com
To mount your server in a cabinet:
1
Remove the two screws from each handle, then set the handles and screws aside.
2
Align the slots in a server rail with the studs on the side of the server, then engage
the slots with the studs and slide the rail back until it stops. (Your server may be
different than the server shown in the example.)
3
Align the locking screw holes in the rails with the threaded screw holes in the server,
then install two locking screws through the each rail.
Server rail
Slot
Slot
Threaded screw hole
Locking screw hole
Locking screw hole
Mounting stud
8510522.book Page 13 Wednesday, March 16, 2005 11:19 AM