Gateway 9415 - Manual (Page 62)

57 www.gateway.com
5
Disconnect the data and power cables from the interposer board.
6
Push in on the blue lever at the back of the drive carrier to release the drive carrier
from the drive bay, then slide the drive carrier out through the front of the server.
7
Press down on the side of the drive carrier to release the drive from the carrier.
8
Disconnect the 44-pin CD drive cable from the back of the interposer board.
9
Pull up on the top of the connector on the back of the CD or DVD drive and remove
the flat flex cable.
10
Remove the four screws securing the rails to the carrier, then remove the rails.
Interposer board
CD or DVD drive Screws
Drive carrier
8510522.book Page 57 Wednesday, March 16, 2005 11:19 AM