Gateway 9415 - Manual (Page 64)

59 www.gateway.com
5
Place the CD or DVD drive in the drive carrier (included with your server) by aligning
the two holes in the left side of the drive with the two alignment pins in the carrier,
then lowering the right side of the drive into the carrier until it clicks into place.
6
Align the connector on the interposer board with the connector on the back of the
CD or DVD drive, then attach the board to the drive with two screws (included with
your server).
7
Attach the 44-pin CD drive cable to the back of the interposer board.
8
Slide the CD or DVD drive assembly into the slim-line bay until it clicks into place.
9
Connect the other end of the 44-pin cable into the connector on the system board.
See
“System board” on page 6 for the location of the connectors on the system board.
Interposer board
CD or DVD drive Screws
Drive carrier
8510522.book Page 59 Wednesday, March 16, 2005 11:19 AM