Gateway 9415 - Manual (Page 131)

126 www.gateway.com
Additional beep codes provided by optional Intel
Management Modules
In addition to the preceding beep codes, the following additional beep codes are provided
if an Intel Management Module is installed:
LED information
The system board in this server includes LEDs that can assist you in troubleshooting your
system. See the following table for a description of these LEDs and the information they
provide:
Beep Codes Description
1 Control panel CMOS clear has been initiated
1-5-1-1 Processor failure. Reseat or replace the failed processor.
1-5-2-1 No processor is installed or the CPU 1 socket is empty.
Reseat or replace the failed processor.
1-5-2-3 Processor configuration error or CPU 1 socket is empty.
Reseat or replace the failed processor. In a
two-processor system, make sure the processors are
identical.
1-5-2-4 Front-side bus select configuration error.
1-5-4-2 DC power unexpectedly lost.
1-5-4-3 Chipset control failure.
1-5-4-4 Power control failure.
LED Name Function Location Color Description
ID Aid in server
identification Front panel and
left back of
system board Blue On = Server identification
enabled
System Fault Visible fault
warning Front panel and
left back of
system board Green or
Orange ■ On = No fault
■ Green blink = Degraded
■ Orange = Critical error or
non-recoverable
■ Orange blink = Non critical
ATA drive
activity Indicate drive
activity Front panel and
left side of
system board Green Blinking = Drive active
8510522.book Page 126 Wednesday, March 16, 2005 11:19 AM