Gateway 9415 - Manual (Page 59)

54 www.gateway.com
9
Open the connector on the back of the diskette drive by pulling up on the connector
cover.
10
Insert one end of the 26-pin diskette drive flat flex cable into the connector, then
push down on the connector cover to lock it into place.
11
Install the other end of the flat flex cable to the interposer board included in the
diskette drive conversion kit.
12
Install the interposer board on the diskette drive carrier with one screw on the right
side.
13
Connect the data and power cables to the interposer board.
14
While guiding the cables, insert the new drive assembly into the center hard drive
bay until it clicks into place.
Interposer
board
8510522.book Page 54 Wednesday, March 16, 2005 11:19 AM