76 operating manual, Rx600 s5 – FUJITSU PRIMERGY RX600 S5 User Manual
Page 76
76
Operating Manual
RX600
S5
Switching the server on and off
Starting up and operation
©
c
ogn
it
as
.
G
e
s
e
lls
c
h
ft
f
ü
r T
e
c
h
ni
k
-D
o
k
u
m
e
n
tat
ion m
b
H
20
10
P
fa
d
:
C
:\
P
rogra
m
m
e
\F
CT
\t
im
_a
pp
\t
im
_l
o
c
a
l\
w
or
k
\P
ICH
OL
\O
B
J
_
D
O
K
U
-4
8
8
8
-0
03
.f
m
–
System already installed:
Ê
Press the On/Off button (see
).
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
The power-on indicator lights up green (item 5 in
).
Ê
Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights up orange.
I
If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
–
Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S2, you can configure
that the server is switched on/off controlled by timer.
–
Ring indicator
The server is switched on by an internal or external modem.
–
Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
TM
).
–
After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS or in iRMC S2).
–
Power button override
The system can be switched off by pressing and holding down the On/Off
button (for approximately 4 - 5 seconds).