FUJITSU PRIMERGY RX600 S5 - Manual (Page 114)

114 Operating Manual RX600 S5
Hot-plug components CSS components
©
c
ogn
it as
. G
e s e
lls
c h
ft f
ü r T
e
c h ni
k -D
o
k u m
e n
tat
ion m
b H
20
10
P
fa
d : C
:\ P
rogra
m
m
e \F
CT
\t im
_a
pp
\t im
_l
o
c a
l\ w
or
k \P
ICH
OL
\O
B
J _ D
O
K U
-4
8 9
1 -0
03
.f
m
Operating the expansion card
Ê Insert the expansion card fastened to the removal tool in the PCI slot.
Ê Close the slot lock (see pos. #2 in figure 28 on page 109 ) by folding it down.
Make sure that the slot lock engages.
Ê If necessary, connect the cables on the expansion card.
Ê Activate the expansion card using either the relevant PCI hot-plug software
or by pressing the light-pipe switch (see pos. #1 in
figure 28 on page 109 ).
The light-pipe switch flashes green. The slot is in the enable sequence.
Ê Wait until the light-pipe switch is constantly green.
The slot is now powered on.
I
If the light-pipe switch continues to flash, an error has occurred.
Remove the expansion card and repeat the procedure as described
above.
Ê Close the server (see "Opening/Closing the server" on page 134 ).