FUJITSU T5440 - Manual (Page 82)

60 SPARC Enterprise T5440 Server Service Manual • June 2011
set
/HOST/bootmode/ value[normal|re
set_nvram|bootscript=string]
bootmode value
[normal|reset_nvram|
bootscript=string] Enables control of the firmware
during system initialization with
the following options:
• normal is the default boot mode.
• reset_nvram resets OpenBoot
PROM parameters to their
default values.
• bootscript=string enables the
passing of a string to the boot
command.
stop/SYS; start/SYS powercycle [-f]
The -f option forces an immediate
poweroff. Otherwise the command
attempts a graceful shutdown. Performs a poweroff followed by
poweron
.
stop/SYS poweroff [-y] [-f]
• -y enables you to skip the
confirmation question.
• -f forces an immediate
shutdown.
Powers off the host server.
start/SYS poweron [-c]
• -c executes a console command
after completion of the poweron
command.
Powers on the host server.
set
/SYS/PS x/prepare_to_remove_acti
on true
removefru PS0|PS1 Indicates if it is okay to perform a
hot-swap of a power supply. This
command does not perform any
action. But this command provides
a warning if the power supply
should not be removed because the
other power supply is not enabled.
reset /SYS reset [-y] [-c]
• -y enables you to skip the
confirmation question.
• -c executes a console command
after completion of the reset
command.
Generates a hardware reset on the
host server.
reset /SP resetsc [-y]
• -y enables you to skip the
confirmation question.
Reboots the service processor.
ILOM Command ALOM CMT Command Description