FUJITSU T5440 - Manual (Page 53)

Managing Faults 31
Related Information
■ “Diagnostic Flowchart” on page 13
■ “Change POST Parameters” on page 31
■ “Run POST in Maximum Mode” on page 32
■ “Detecting Faults Using POST” on page 46
■ “Clear Faults Detected During POST” on page 52
■ SPARC Enterprise T5440 Server Installation and Setup Guide
■ SPARC Enterprise T5440 Server Administration Guide
▼ Change POST Parameters
1. Access the ILOM prompt.
See “Connecting to the Service Processor” on page 25 .
2. Use the ILOM commands to change the POST parameters.
Refer to Component Fault on page 35 for a list of ILOM POST parameters and
their values.
The set /SYS keyswitch_state command sets the virtual keyswitch
parameter. For example:
To change individual POST parameters, you must first set the keyswitch_state
parameter to normal. For example:
normal POST output displays all test and informational
messages.
max POST displays all test, informational, and some
debugging messages.
-> set /SYS keyswitch_state=Diag
Set ‘keyswitch_state’ to ‘Diag’
-> set /SYS keyswitch_state=Normal
Set ‘ketswitch_state’ to ‘Normal’
-> set /HOST/diag property=Min
Parameter Values Description