Ilom-to-alom cmt command reference – FUJITSU T5440 User Manual

Page 80

Text mode
Original mode

SPARC Enterprise T5440 Server Service Manual • June 2011

1. At the -> prompt, set the component_state property to Enabled.

2. Reset the server so that the ASR command takes effect.

Note –

In the ILOM shell there is no notification when the system is actually

powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.

ILOM-to-ALOM CMT Command
Reference

The following table describes the typical commands for servicing a server. For
descriptions of all ALOM CMT commands, issue the help command or refer to the
following documents:

■

Integrated Lights Out Manager 3.0 Concepts Guide

-> set /SYS/MB/CPU0/CMP0/BR1/CH0/D0 component_state=Enabled

-> stop /SYS

Are you sure you want to stop /SYS (y/n)? y

Stopping /SYS

-> start /SYS

Are you sure you want to start /SYS (y/n)? y

Starting /SYS