FUJITSU T5440 - Manual (Page 101)

Servicing Customer-Replaceable Units 79
EXAMPLE: Sample Ap_id Output
▼ Install a Hard Drive (Hot-Plug)
Installing a hard drive into the server is a two-step process. You must first install a
hard drive into the desired drive slot. Then you must configure that drive to the
server.
Perform the following process to install a hard drive.
1. If necessary, remove the blank panel from the chassis.
Note – The server might have up to three blank panels covering unoccupied drive
slots.
2. Align the replacement drive to the drive slot.
Hard drives are physically addressed according to the slot in which they are
installed. If you removed an existing hard drive from a slot in the server, you must
install the replacement drive in the same slot as the drive that was removed.
3. Slide the drive into the drive slot until it is fully seated.
Ap_id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/d1t0d0 disk connected configured unknown
c0::dsk/d1t1d0 disk connected configured unknown
usb0/1 unknown empty unconfigured ok
usb0/2 unknown empty unconfigured ok
usb0/3 unknown empty unconfigured ok
usb1/1 unknown empty unconfigured ok
usb1/2 unknown empty unconfigured ok
usb1/3 unknown empty unconfigured ok
usb2/1 unknown empty unconfigured ok
usb2/2 unknown empty unconfigured ok
usb2/3 unknown empty unconfigured ok
usb2/4 unknown empty unconfigured ok
usb2/5 unknown empty unconfigured ok
usb2/6 unknown empty unconfigured ok
usb2/7 unknown empty unconfigured ok
usb2/8 unknown empty unconfigured ok
----------------------------