FUJITSU T5440 - Manual (Page 143)

Servicing Field-Replaceable Units 121
Note – Avoid bending the bezel by gradually pulling it from the middle and both
ends simultaneously.
▼ Install the Front Bezel
1. Align the bezel with the chassis front panel.
2. Press the bezel onto the front panel.
The bezel is oriented with four guide pins, and is secured with three snap-in posts.
Next Steps
■ “Slide the Server Into the Rack” on page 155
■ If you performed any additional service procedures, see “Power On the Server” on
page 157 .