Main memory – FUJITSU TX300 User Manual
Page 37
TX300 S6
Options Guide
37
5
Main memory
V
CAUTION!
●
Before installing/removing memory to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also
unplug all power cords from the power outlet. Failure to do so can
cause electric shock.
●
A memory module consists of parts that are very vulnerable to
damage by static electricity, and can easily be damaged by static
electricity in the human body. Before handling memory modules, first
touch a metal part of the server to discharge static electricity.
●
Do not touch the circuitry on boards and soldered parts. Hold the
metallic areas or the edge of the circuit boards.
●
Do not install unauthorized third party memory modules. Doing so
may cause electric shock, a fire, or failures.
●
Wait for a sufficient period of time after server shutdown before
installing or removing memory modules. Failure to do so may cause
burns. When installing or removing memory modules, make sure to
remove the screws at the specified points only. Failure to do so may
cause injury. It may also cause failures.
●
Touch only the specified part of the printed circuit board. Failure to do
so may cause injury. It may also cause failures.
●
Do not insert and remove memory modules repeatedly. Doing so may
cause failures.
●
If the memory module has not been correctly inserted, it may cause
a fire. Insert the memory module with attention to its direction.
●
If a memory module is installed and you pull the securing clips
strongly outward, the memory module pops up. Doing so may cause
a device failure.
●
Follow the safety instructions in the