Fortinet FortiMail 3.0 MR4 - Manual (Page 328)

FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
328 06-30004-0420-20080814
system ha rservice set
system ha rservice
Use this command to configure HA backup unit remote services monitoring so that an active-passive
HA backup unit monitors the primary unit to verify that the primary unit can accept SMTP service, POP
service (POP3), and Web service (HTTP) connections.
For each protocol you must specify the check time interval in minutes to wait between checks and the
response time to wait for a response. You must also specify how many times the check fails before the
backup unit decides that the primary unit has failed and a failover occurs.
If the backup unit detects a remote services failure, the backup unit HA effective operating mode
changes to master and the primary unit effective operating mode changes to off. The backup unit
becomes the new primary unit.
Syntax
set system ha rservice {smtp | pop | imap | http}
Keywords/Variables Description Default
{smtp | pop | imap |
http}
The service to configure remove service monitoring for.
• smtp to configure SMTP remote service monitoring.
• pop to configure POP3 remote service monitoring.
• imap to configure IMAP remote service monitoring.
• http to configure HTTP remote service monitoring.
The IP address to connect to for testing each remote service.
You can enter the same IP address or different IP addresses for
each service. Normally you would enter the IP address of the
FortiMail interface that processes email. If you add the IP
address of the HA interface of the primary unit, checking takes
place over the HA heartbeat link. 0.0.0.0
The TCP port used for the service. In most cases
would the standard TCP port for
the service.
0
The check time interval in seconds to wait between remote
service checks.
The check time interval range is 1 to 60 minutes. Set the check
time interval to 0 to disable remote service monitoring. 0
The response wait time in seconds to wait for a response to a
remote service check.
The response wait time range is 1 to a very high number of
seconds. Set the response wait time to 0 to disable remote
service monitoring. 0
The number of consecutive times remote service monitoring
detects a failure before the backup unit changes its effective
operating mode to master.
The number of times the check fails range is 1 to a very high
number. Set the number of times the check fails to 0 to disable
remote service monitoring. 0