Fortinet FortiMail 3.0 MR4 - Manual (Page 315)

set system ha {cpeer | interface | peer | secondary-interface | secondary-peer}
FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
06-30004-0420-20080814
315
The primary heartbeat local IP address and netmask for
this FortiMail unit. When the FortiMail unit is operating in
HA mode, you can enter get system interface
to display this IP address and
netmask, where is the name of the
primary heartbeat interface.
primary-local_ipv4
of the primary unit must match
primary-peer_ipv4 of the backup unit. Normally you
would set primary-local_ipv4 on the primary unit to
10.0.0.1
.
In an active-passive HA group primary-local_ipv4
of the backup unit must match primary-peer_ipv4 of
the primary unit. Normally you would set primary-
local_ipv4
on the backup unit to 10.0.0.2.
In a config only HA group you would normally set
primary-local_ipv4
on the first backup unit to
10.0.0.2 , primary-local_ipv4 on the second
backup unit to 10.0.0.3, primary-local_ipv4 on
the third backup unit to 10.0.0.4, and so on.
10.0.0.1
255.255.255.0
The name of the network interface to be used for the
primary heartbeat. The default primary heartbeat
interface is the network interface with the highest
number. In most cases you would not have to select a
different network interface.
The primary heartbeat IP address for the other FortiMail
unit in the HA group. This is the IP address that the
FortiMail unit primary heartbeat expects to be able to
connect to find the other FortiMail unit in the HA group.
primary-peer_ipv4
of the primary unit must match
the primary-local_ipv4 of the backup unit. Normally
you would set primary-peer_ipv4 on the primary unit
to 10.0.0.2.
primary-peer_ipv4
of the backup unit must match
the primary-local_ipv4 of the primary unit. For an
active-passive or a config only HA group you would set
primary-peer_ipv4
of the backup unit or units to
10.0.0.1 .
10.0.0.2
255.255.255.0
In an active-passive HA group, the secondary heartbeat
local IP address and netmask for this FortiMail unit.
When the FortiMail unit is operating in HA mode, you can
enter get system interface to
display this IP address and netmask, where
is the name of the secondary
heartbeat interface.
secondary-local_ipv4
of the primary unit must
match secondary-peer_ipv4 of the backup unit. You
could set secondary-local_ipv4 on the primary unit
to 10.1.1.1.
secondary-local_ipv4
of the backup unit must
match secondary-peer_ipv4 of the primary unit. You
could set primary-local_ipv4 on the backup unit to
10.1.1.2
.
0.0.0.0
0.0.0.0
Keywords/Variables Description Default