Fortinet FortiMail 3.0 MR4 - Manual (Page 325)

set system ha passwd
FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
06-30004-0420-20080814
325
system ha passwd
Use this command to Change HA group shared password.
In most cases you do not have to change any of the HA daemon settings. However you should change
the shared password. The shared password is not synchronized and must be set separately on the
primary and backup units.
Syntax
set system ha passwd
Example
Enter the following command to set the shared password to PassW4D.
set system ha passwd Passw4D
History
Related topics
Note: Use the set system ha config command to configure HA daemon settings. Other HA
daemon configuration commands include
“set system ha config” on page 313 , “set system ha data” on
page 318 , “set system ha datadir” on page 319 , and “set system ha monitor” on page 322 .
Keywords/Variables Description Default
Enter a password for the HA group. The password must be the same on
the primary and backup FortiMail units. The password must be a least 1
character. change_me
FortiMail v3.0 New.
• set system ha config
• set system ha {cpeer | interface | peer |
secondary-interface | secondary-peer}
• set system ha data
• set system ha datadir
• set system ha lservice
• set system ha mode
• set system ha monitor
• set system ha on-failure
• set system ha remote-as-heartbeat
• set system ha {restart | restore | resync}
• set system ha rservice
• set system ha takeover