Fortinet FortiMail 3.0 MR4 - Manual (Page 319)

set system ha datadir
FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
06-30004-0420-20080814
319
system ha datadir
Use this command to enable or disable synchronizing FortiMail mail data including the system mail
directory, user home directories, and the MTA spool directories (FortiMail queues). Each time you
enter this command you must enable or disable synchronizing all three types of mail data. Because the
command does not include keywords, using the command involves entering the correct enable or
disable sequence in the correct order as follows:
• First: enable or disable synchronizing the system mail directory.
• Second: enable or disable synchronizing the user home directories.
• Third: enable or disable synchronizing the MTA spool directories (FortiMail queues).
Synchronization of all three types of mail data is disabled by default.
Syntax
set system ha datadir {enable | disable} {enable | disable} {enable |
disable}
Example
Enter the following command to:
• Enable synchronizing the system mail directory.
• Disable synchronizing the user home directories.
• Disable synchronizing the MTA spool directories (FortiMail queues).
set system ha datadir enable disable disable
History
Related topics
Note: Use the set system ha config command to configure HA daemon settings. Other HA
daemon configuration commands include
“set system ha config” on page 313 , “set system ha data” on
page 318 , “set system ha monitor” on page 322 , and “set ” on page 324 .
FortiMail v3.0 New.
• set system ha config
• set system ha {cpeer | interface | peer |
secondary-interface | secondary-peer}
• set system ha data
• set system ha lservice
• set system ha mode
• set system ha monitor
• set system ha on-failure
• set system ha passwd
• set system ha remote-as-heartbeat
• set system ha {restart | restore | resync}
• set system ha rservice
• set system ha takeover