System ha config, Syntax, Example – Fortinet FortiMail 3.0 MR4 User Manual
Page 313: History, Related topics
set
system ha config
FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
06-30004-0420-20080814
313
system ha config
Use this command to change the TCP port and time interval for synchronizing the FortiMail
configuration.
In most cases you do not have to change the default settings. However if you are making a lot of
configuration changes, you may want to reduce the time between synchronizations so that changes
are not lost if a failover occurs. The default
operation, synchronizing the configuration once every 60 minutes is usually sufficient.
You can also synchronize the configuration manually. See
“set system ha {restart | restore | resync}”
For more information about how FortiMail HA synchronizes the configuration and about what is
synchronized and what is not synchron
.
Syntax
set system ha config
Example
Enter the following command to set the FortiMail configuration synchronization time interval to 30
minutes. The command maintains the default value of the synchronization port as 20001.
set system ha config 20001 30
History
Related topics
Note: Use the set system ha config command to configure HA daemon settings. Other HA daemon
configuration commands include
“set system ha data” on page 318
,
“set system ha datadir” on page 319
system ha monitor” on page 322
, and
.
Keywords/Variables
Description
Default
The TCP port used for synchronizing the configuration of the primary unit to
the backup unit.
20001
How often HA synchronizes the configuration. The minimum
is every 15 minutes. The maximum configuration
synchronization time is 999 minutes. If
the configuration is not synchronized.
60
FortiMail v3.0
New.
•
set system ha {cpeer | interface | peer |
secondary-interface | secondary-peer}
•
•
•
•
•
•
•
•
set system ha remote-as-heartbeat
•
set system ha {restart | restore | resync}
•
•