HP 2600/2700 User Manual
Page 89
Back view of the HP all-in-one
1 Telephone wall jack
2 Phone cord supplied in the box with your HP all-in-one connected to the "1-LINE" port
To set up your HP all-in-one with a distinctive ring service
1
Using the phone cord supplied in the box with your HP all-in-one, connect one end
to your telephone wall jack, then connect the other end to the port labeled "1-LINE"
on the back of your HP all-in-one.
Caution
If you do not use the supplied cord to connect from the telephone
wall jack to your HP all-in-one, you might not be able to fax successfully.
This special phone cord is different from the phone cords you might already
have in your home or office. If the supplied phone cord is too short, see
phone cord that came with my HP all-in-one is not long enough
information on extending it.
2
Set up the HP all-in-one to answer incoming calls automatically:
a
Press
Setup
, press
4
, and then press
3
.
This displays the
Basic Fax Setup
menu and then selects
Auto Answer
.
b
Press
1
to select
On
.
c
Press
OK
to accept the setting.
3
Change the
Answer Ring Pattern
setting to the pattern that has been assigned to
your fax number by the telephone company, for example, double rings or triple
rings.
For information on changing this setting, see
Change the answer ring pattern
.
Note
Your HP all-in-one is factory-set to answer all ring patterns. If you do not set
the correct ring pattern assigned to your fax number by the telephone
company, your HP all-in-one might answer both voice calls and fax calls or
it might not answer at all.
4
(Optional) Change the
Rings to Answer
setting to one ring or two rings.
For information on changing this setting, see
Set the number of rings before
.
5
Run a fax test. For information, see
.
Your HP all-in-one will automatically answer incoming calls that have the ring pattern
you selected (
Answer Ring Pattern
setting) after the number of rings you selected
Chapter 10
86
HP Photosmart 2600/2700 series all-in-one
Fax setup