HP 2600/2700 - Manual (Page 41)

2 Tap a stack of paper on a flat surface to align the edges, and then check the paper
for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type.
3 Insert the stack of paper into the input tray with the short edge forward and the
print side down. Slide the stack of paper forward until it stops.
Tip If you are using letterhead, insert the top of the page first with the print side
down. For more help on loading full-size paper and letterhead, refer to the
diagram engraved in the base of the input tray.
4 Slide the paper-width and paper-length guides inward until they stop at the edges
of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input
tray and is no higher than the top of the paper-width guide.
5 Replace the output tray.
Chapter 5
38 HP Photosmart 2600/2700 series all-in-one
Load
originals
and
load
paper